REMOTE CONTROL OF EVERYTHING

MOVENTIV® 80 simplifies operation. Its motorization is connected 3.0 thanks to the smartphone application we have developed. Control the opening and closing of your doors with a simple gesture via Bluetooth. This free application will also allow you to start up quickly. It’s as easy to use as it is to install. You connect the mains and control with the smartphone “Plug and Play”.

DOWNLOAD THE FREE MOVENTIV® APPLICATION

PAIRING THE APPLICATION WITH YOUR MOVENTIV®

 

To use it, check that you have activated Bluetooth on your phone.

From the mobile app, launch a “motor” search.
Once you have selected your motor, set Switch 1 to OFF and tap the “Prg” button. You should see a constant magenta light.
In the app, tap on MOVENTIV® and accept the pairing request to finish.
You can then rename your MOVENTIV® and associate it to a room.

You can now use your MOVENTIV®!

Simplified configuration through the application

 

Installation and commissioning are simplified by the smartphone application thanks to Plug & Play: Connect your MOVENTIV® to the mains and configure it from your phone via Bluetooth. It’s so easy, it saves you a lot of time!

 

Door weight selection: <20kg; 20-30kg; 30-40kg; 40-50kg; 50-60kg

 

Input type setting: radar or button

 

 

Triggering of learning stops

 

Reset of the “maintenance” intermediate counter

Activation or deactivation of the lights:
– Activation of LED banner output
– Deactivation of the LED under the product

 

Closing speed adjustment
Opening speed adjustment

 

Setting the time delay before the door closes

Operate your sliding door remotely and much more…

Opening, closing… you can control your motorisation with your smartphone, in the same way as with a remote control.
But the application goes even further!

 

 

 

Open/close control

 

Timed opening control

 

Locking the door

 

Switching on the LED headband (torch)

All the information you need to facilitate the maintenance of your MOVENTIV®.

You can know the position of the switches, know the number of cycles since the commissioning, set your input type (radar or button)…

Switch states visible from the application

General information:
– Current profile (weight range)
– Date of first use

Maintenance:
– Date of last maintenance
– Number of cycles since last maintenance

Software versions:
– Drive software version
– Bluetooth software version

Additional information – diagnostic help:
– Number of restarts
– Number of cycles since last restart
– Number of obstacle detection